P104-WDG-CSM - ACCES I/O P104-WDG-CSM 4-pin above plus; 6-pin right-angle 2x3 header...
Request Quote
For Price
- Part Number:
- P104-WDG-CSM
- Model Number:
- P104-WDG-CSM
- Make:
- ACCESI I/O
- Lead Time:
- Available
- Qty In Stock:
- Available
ACCES I/O P104-WDG-CSM 4-pin above plus; 6-pin right-angle 2x3 header (1-6)2-pin right-angle 1x2 header (15-16) 10-pin rt-angle 2x5 header (25-34) PC/104 Plus Watchdog Timer Status Monitor Simple Type: Data Acquisition
The Computer Status Monitor (CSM) version includes features in the economy model and adds capability to monitor the health and control various computer functions. The PCI-Bus 5V and ±12V are monitored and if any voltage varies by more than 6%, an interrupt can be generated. The temperature monitor compares an on-board temperature sensor output to a preset reference (approximately 50°C). A status register indicates normal or high temperature and can also generate an interrupt. The temperature measurement circuit uses an on-board 8-bit A/D as the digitizer. This model also provides one general-purpose opto-isolated input. Two digital isolated outputs are provided to control/switch external events in response to CSM conditions. In parallel to these two isolated outputs are two non-isolated digital outputs that can sink/source up to 15mA and can drive LEDs to indicate the switched event of the isolated outputs or simply output to another device the same digital state. A fused 5V external power pin is provided to bias external LEDs when used with non-isolated digital outputs. A push button reset input is also provided to directly initiate a system reset.
For Resellers and High Volume Orders:
Please request a quote to obtain preferred pricing.
Features
- External fused 5V and 12V power
- Fan status and speed control
- General purpose opto-isolated input
- Light sensor for enclosure security
- Opto-isolated input to trigger reset
- PC/104 bus pass through connector
- PC/104 Plus Watchdog Timer card with software selectable timeout from 4 µsec
- PCI/104 power monitor / limit alarm interrupt
- Supported in DOS, Windows, Linux
- Temperature measurement with 8-bit A/D
- Temperature monitor / alarm
- Temperature sensor with calibration pot
- TTL reset pushbutton input
- Two general purpose 8-bit A/D inputs
- Two isolated outputs, current limited
- Watchdog open collector reset outputs
Specifications
- Digital Inputs: Isolated: Two, limited through a 330 ohm resistor - one dedicated RESET input, one general purpose available
- Digital Outputs: Isolated: Two, 5V through a 330 ohm resistor Non-Isolated: Two, controlled with isolated outputs to drive LED (up to 15mA sink/source) Reset Outputs: One active low open collector, One active high with 1K pull-up Fan Pulse Width 120 nsec. min., 31 msec. max.
- Environmental: Operating Temp: 0 to +70°C (optional -40 to +85°C) Storage Temp: -50°C to +120°C Humidity: 10% to 90% RH, non-condensing Power: +5VDC @ 125mA typical
- Status Register: Voltages: If +5V, +12V or -12V varies by more than ±6% Temp Alarm: IRQ and status register indication if temperature is above 122°F (50°C) Temp Digitizer: 8-bit ADC, LSB
- Watchdog Timer: Time-out: Software selectable from 4 µsec to 2060 sec Clock: 2.08333 MHz, derived from computer clock (33 MHz ÷ 16) Address: 8-Bit I/O Mapped
Applications
- None Available
Aliases
- None Available